Colaplex PMMA Gold GLUE


    Product Information

    COLAPLEX PMMA GOLD glue is a viscous glue indicated for joining methacrylate materials (PMMA) for extrusion and casting.

    • Viscosity approx .: Up to 1000 mPa-s.
    • Density: 1,21 gr./ cm3
    • Color: colorless to slightly yellow.
    • It has no flash point.
    • Shelf life: more than three years under normal storage conditions. The degradation of its components is very slow.
    • To regulate the viscosity of COLAPLEX PMMA GOLD, Pegacril DX2 (viscous) can be used as a diluent.
    • Hardening of the product by absorption, dissolution and evaporation of the treated pieces.


    Minimum training in occupational risk prevention is recommended for the personnel who will handle this product in order to facilitate the understanding and interpretation of this safety data sheet, as well as the product labeling.

    Directive 67/548 / EC and Directive 1999/45 / EC:

    Contains dichloromethane, nitromethane and acrylic polymer (PMMA) UN 2810

    The product classification has been carried out in accordance with RD 363/1995 (Directive 67/548 / CE) and RD255 / 2003 (Directive 1999/45 / CE), adapting their provisions to Regulation (CE) nº1907 / 2006 (REACH Regulation) according to RD 1802/2008. Carc. Cat 3: R40 – Possible carcinogenic effects, R22: Harmful if swallowed.

    Regulation No. 1272/2008 (CLP):

    H302 – Harmful if swallowed. H351 – Suspected of causing cancer. H319 – Causes serious eye irritation. H336 – May cause drowsiness or vertigo.

    For gluing and bonding extrusion and casting methyl acrylic (PMMA) materials.
    High-tech jobs in the industrial sector.
    The pieces to be treated must be stress-free, thus avoiding micro-cracks due to the action of the solvent.
    High resistance when the glue has evaporated and the polymer is attached to the parts.
    You can also carry out previous tests for gluing with other plastic materials.


    The gluing with COLAPLEX PMMA GOLD glue is carried out indistinctly in extrusion and cast methacrylate. The union is carried out by evaporation of the solvent, leaving the polymer adhered to the pieces.

    The edges to be glued must be perfectly flat to avoid the formation of bubbles.

    COLAPLEX PMMA GOLD is applied with a small bottle or syringe provided with a cannula or needle, on the edges of the pieces to be joined, exerting a little pressure on them. Handling is recommended in a dry place at a temperature of 20-24ºC. The gluing time is a few minutes and after this, COLAPLEX PMMA GOLD offers a colorless finish. It does not fill in the gaps completely. COLAPLEX PMMA GOLD should not be used if there is moisture condensation, as it can whiten the bond.

    The transport and movement of the piece after gluing must take place after four hours. The pieces must be dried in the open air and without wrapping so that the solvent evaporates. Complete evaporation of residual solvent will take place after 48 hours in the open air.

    To clean greases and static charges, it is recommended to use Netacril PT.